14n and not powering down

Today after shooting, I turned the power off and everything stayed on. I turned on, off again and the LCD displayed the last image shot, however the aperture and shutter display turned off. Should I be concerned or do I have something set wrong?

[JonGary]

Was the camera connected to your computer? If so, the processor in the camera stays powered until you unplug it.

[Warren_Sarle]

I've had that happen when the battery got too low to release the shutter. I put in a fresh battery and tried various things until it started working again. Unfortunately, I don't remember what it was that got it working again. Maybe reinstalling the firmware?

I tried tethered to the computer, however the camera was never recognized. I was printing proofs at the same time? I was using battery power, then I went outside for some additional bridal shots, it was when I was riding back I noticed the image on the LCD, the battery was low? I'll install a fresh battery and try again tonight, with all the different things I did during the session, I thought that trying to thether to the computer might have done something?

I just installed a fresh battery and it's doing everything right again. Is there something about when the battery gets low? Anyway alls well, thanks for replying quickly

[rainer_viertlboeck]

this happened sometimes to me also. i power the camera down with its power knob and nothing happened. just removing the battery powered it down,- when i put the battery again in the camera everything works fine... no idea whats that.

[jono_slack]

It doesn't power down - this happens to me occasionally.

Could this be it?